MAX® 10 FPGA Device Family Pin Connection Guidelines

ID 683232
Date 8/20/2024
Public

Example 5— MAX® 10 (Single Supply) FPGA

Note: Altera recommends that you create a Quartus® Prime design, enter your device I/O assignments, and compile the design. The Quartus® Prime software checks your pin connections according to I/O assignment and placement rules. The rules differ from one device to another based on device density, package, I/O assignments, voltage assignments, and other factors that are not fully described in this document or the device user guides.
Table 14.  Power Supply Sharing Guidelines for MAX® 10 (Single Supply) FPGA – Using the ADC Feature and VCCIO[2..8] Pins are Powered Up 3.0 V/3.3 V (E144, M153, U169, and U324 Packages)Example Requiring 2 Power Regulator
Power Pin Name Regulator Count Voltage Level (V) Supply Tolerance Power Source Regulator Sharing Notes
VCC_ONE 1 3.0/3.3 ±5% Switcher 5 Share Both VCCA and VCC_ONE must share a single power source using proper isolation filter.
VCCA Isolate
VCCIO1B 2 3.0/3.3 ±5% Switcher5 Share You have the option to share VCCIO1B and VCCIO[2..8] when these pins are powered up at 3.0V/3.3V.
VCCIO[2..8]
VCCIO1A Isolate You have the option to share VCCIO1A with VCCIO1B and VCCIO[2..8] using proper isolation filter.
Note:
  1. Use the EPE (Early Power Estimation) tool to assist in determining the power required for your specific design.
  2. Each board design requires its own power analysis to determine the required power regulators needed to satisfy the specific board design requirements. An example block diagram using the MAX® 10 FPGA device is provided in the following figure.
  3. Refer to the MAX® 10 FPGA Configuration User Guide for maximum ramp rate requirement.
Figure 5. Example Power Supply Sharing Guidelines for MAX® 10 (Single Supply) FPGA – Using the ADC Feature and VCCIO[2..8] Pins are Powered Up 3.0 V/3.3 V (E144, M153, U169, and U324 Packages)
5 When using a switcher to supply these voltages, the switcher must be a low noise switcher as defined in Note 9 of the Notes to the MAX® 10 FPGA Pin Connection Guidelines.