HDMI Intel® Arria 10 FPGA IP Design Example User Guide

ID 683156
Date 7/29/2022
Public
Document Table of Contents

3.2. Hardware and Software Requirements

Intel uses the following hardware and software to test the design example.

Hardware

  • Intel® Arria® 10 GX FPGA Development Kit
  • HDMI Source (Graphics Processor Unit (GPU))
  • HDMI Sink (Monitor)
  • Bitec HDMI FMC 2.0 daughter card (Revision 11)
  • HDMI cables
Note: You can select the revision of the Bitec HDMI daughter card by setting the local parameter BITEC_DAUGHTER_CARD_REV to 4, 6, or 11 in the top-level file ( a10_hdmi2_demo.v ). When you change the revision, the design may swap the transceiver channels and invert the polarity according to the Bitec HDMI daughter card requirements. If you set the BITEC_DAUGHTER_CARD_REV parameter to 0, the design does not make any changes to the transceiver channels and the polarity.

Software

  • Intel® Quartus® Prime version 18.1 and later (for hardware testing)
  • ModelSim* - Intel® FPGA Edition, ModelSim* - Intel® FPGA Starter Edition, , Riviera-PRO* , VCS* (Verilog HDL only)/ VCS* MX, or Xcelium* Parallel simulator

Did you find the information on this page useful?

Characters remaining:

Feedback Message