Intel® Quartus® Prime Pro Edition User Guide: Third-party Simulation

ID 683870
Date 12/21/2022
Public

A newer version of this document is available. Customers should click here to go to the newest version.

Document Table of Contents

3.2.2. Passing Parameter Information from Verilog HDL to VHDL

You must use in-line parameters to pass values from Verilog HDL to VHDL.

By default, the x_on_violation_option logic option is enabled for all design registers, resulting in an output of “X” at timing violation. To disable “X” propagation at timing violations on a specific register, disable the x_on_violation_option logic option for the specific register, as shown in the following example from the Intel® Quartus® Prime Settings File (.qsf).

set_instance_assignment -name X_ON_VIOLATION_OPTION OFF -to \ <register_name>

In-line Parameter Passing Example

lpm_add_sub#(.lpm_width(12), .lpm_direction("Add"),
.lpm_type("LPM_ADD_SUB"),
.lpm_hint("ONE_INPUT_IS_CONSTANT=NO,CIN_USED=NO" ))

lpm_add_sub_component (
        .dataa (dataa),
        .datab (datab),
        .result (sub_wire0)
);
Note: The sequence of the parameters depends on the sequence of the GENERIC in the VHDL component declaration.