CPRI Intel® FPGA IP User Guide

ID 683595
Date 11/15/2022
Public

A newer version of this document is available. Customers should click here to go to the newest version.

Document Table of Contents

3.18.4. Multi-Hop Delay Measurement

In a multi-hop system, you must combine the delays between and through the different CPRI masters and CPRI RE slaves to determine the round-trip delay.

To determine the round-trip delay of a full multi-hop system, you must add together the values in the ROUND_TRIP_DELAY registers of the REC and RE masters in the system, plus the delays through the external routers, and subtract the loopback delay from all the hops except the final hop.

Round-trip delay = Σi round_trip_delay (hop i) + Σj (TBdelayUL + TBdelayDL)(j) – Σj T_S_Rx_Tx(j)

where the REC and RE masters in the configuration are labeled i = 0, 1, ...,n and the routing layers in the configuration, and their uplink and downlink delays, are labeled j = 0, 1, ...(n-1).

As the equation shows, you must omit the loopback delay from the single-hop calculation for all but the final pair of CPRI link partners. The loopback delay is only relevant at the turnaround point of the full multi-hop path.

Did you find the information on this page useful?

Characters remaining:

Feedback Message