HDMI Intel® Arria 10 FPGA IP Design Example User Guide

ID 683156
Date 12/27/2022
Public
Document Table of Contents

3.2. Hardware and Software Requirements

Intel uses the following hardware and software to test the design example.

Hardware

  • Intel® Arria® 10 GX FPGA Development Kit
  • HDMI Source (Graphics Processor Unit (GPU))
  • HDMI Sink (Monitor)
  • Bitec HDMI FMC 2.0 daughter card (Revision 11)
  • HDMI cables
Note: You can select the revision of your Bitec HDMI daughter card. Set the local parameter BITEC_DAUGHTER_CARD_REV to 4, 6, or 11 in the top-level file ( a10_hdmi2_demo.v ). When you change the revision, the design may swap the transceiver channels and invert the polarity according to the Bitec HDMI daughter card requirements. If you set the BITEC_DAUGHTER_CARD_REV parameter to 0, the design does not make any changes to the transceiver channels and the polarity. For HDMI 2.1 design examples, under the Design Example tab, set HDMI Daughter Card Revision to either Revision 9, Revision 4, or no daughter card. The default value is Revision 9.

Software

  • Intel® Quartus® Prime version 18.1 and later (for hardware testing)
  • ModelSim* - Intel® FPGA Edition, ModelSim* - Intel® FPGA Starter Edition, , Riviera-PRO* , VCS* (Verilog HDL only)/ VCS* MX, or Xcelium* Parallel simulator

Did you find the information on this page useful?

Characters remaining:

Feedback Message