22.214.171.124. Specify Instance-Specific Constraints in Assignment Editor 126.96.36.199. Specifying Multi-Dimensional Bus Constraints 188.8.131.52. Specify I/O Constraints in Pin Planner 184.108.40.206. Plan Interface Constraints in Interface Planner and Tile Interface Planner 220.127.116.11. Adjust Constraints with the Chip Planner 18.104.22.168. Constraining Designs with the Design Partition Planner
22.214.171.124. Advanced I/O Timing Analysis Reports
The following reports show advanced I/O timing analysis information:
|I/O Timing Report||Description|
|Timing Analyzer Report||Reports signal integrity and board delay data.|
|Board Trace Model Assignments report||Summarizes the board trace model component settings for each output and bidirectional signal.|
|Signal Integrity Metrics report||Contains all the signal integrity metrics calculated during advanced I/O timing analysis based on the board trace model settings for each output or bidirectional pin. Includes measurements at both the FPGA pin and at the far-end load of board delay, steady state voltages, and rise and fall times.|
Note: By default, the Timing Analyzer generates the Slow‑Corner Signal Integrity Metrics report. To generate a Fast-Corner Signal Integrity Metrics report you must change the delay model by clicking Tools > Timing Analyzer.
Did you find the information on this page useful?