Visible to Intel only — GUID: sss1410335361820
Ixiasoft
1.1.1. Operating Conditions
1.1.2. User Flash Memory Operations During In-System Programming
1.1.3. Interrupting In-System Programming
1.1.4. MultiVolt Devices and Power-Up Sequences
1.1.5. I/O Pins Tri-Stated During In-System Programming
1.1.6. Pull-Up and Pull-Down of JTAG Pins During In-System Programming
Visible to Intel only — GUID: sss1410335361820
Ixiasoft
1.4.3. Check the Voltage Levels of the Board During In-System Programming
Monitor the VCCINT or VCCA, VCC_ONE/VCC and VCCIO signal for all banks on your JTAG chain with an oscilloscope.
Set the trigger to the minimum level listed in the “Recommended Operating Conditions” table of the appropriate Device Family Datasheet. If a trigger occurs during in-system programming, the devices may need more current than is being supplied by the existing power supply. You can replace the existing power supply with one that provides more current.