18.104.22.168. Specify Instance-Specific Constraints in Assignment Editor 22.214.171.124. Specify NoC Constraints in NoC Assignment Editor 126.96.36.199. Specify I/O Constraints in Pin Planner 188.8.131.52. Plan Interface Constraints in Interface Planner and Tile Interface Planner 184.108.40.206. Adjust Constraints with the Chip Planner 220.127.116.11. Constraining Designs with the Design Partition Planner
3.2.1. Assigning to Exclusive Pin Groups 3.2.2. Assigning Slew Rate and Drive Strength 3.2.3. Assigning I/O Banks 3.2.4. Changing Pin Planner Highlight Colors 3.2.5. Showing I/O Lanes 3.2.6. Assigning Differential Pins 3.2.7. Entering Pin Assignments with Tcl Commands 3.2.8. Entering Pin Assignments in HDL Code
18.104.22.168. Flow Controls
The Flow control panel provides immediate access to common Interface Planner commands from anywhere within Interface Planner. The Flow controls appear in order of a typical interface planning flow.
|Allows you to select and open an Intel® Quartus® Prime project in Interface Planner. Use of Open Project command is only required when using Interface Planner in standalone mode.
|Initialize Interface Planner
|Loads the synthesis netlist, starts the Fitter verification engine, and imports assignments from your Intel® Quartus® Prime project.
|Opens the Assignments tab, which allows you to review and reconcile any conflicting assignments that Interface Planner imports from your project. Enable or disable specific project assignments to resolve any conflicts.
|Applies the enabled project assignments to your interface plan. You cannot perform periphery planning on the Plan tab until you update the plan.
|Opens the Plan tab for placing logic in the interface plan.
|Verifies that all constraints in the interface plan are compatible with placement of all remaining unplaced design elements. You can then directly locate and resolve the source of any reported validation errors. You must successfully validate the plan before running Write Plan File.
|Saves your interface plan as a Tcl script file for subsequent application in your project. This command is available only after successfully running Validate Plan.
|Opens the Reports tab for filtering data and finding entities and locations.
|View Summary Reports
|Opens the Interface Planner Summary report that summarizes the percentage of placed and unplaced periphery cells.