DisplayPort IP Design Example User Guide: Agilex™ 5 FPGAs
ID
823560
Date
8/15/2025
Public
1. DisplayPort IP Design Example Quick Start Guide
2. DisplayPort IP Design Examples
3. DisplayPort SST Parallel Loopback without PCR Design Example
4. DisplayPort SST Parallel Loopback with AXI4-S Video Interface Design Example
5. DisplayPort SST TX-Only Design Example
6. DisplayPort SST RX-Only Design Example
7. Document Revision History for the DisplayPort IP Design Example User Guide: Agilex™ 5 FPGAs
1.5.1. Compiling and Testing the Design Using Agilex™ 5 E-Series 065B Premium Development Kit
1.5.2. Compiling and Testing the Design Using Agilex™ 5 E-Series 065B Modular Development Kit Connector with No FMC Mode
1.5.3. Compiling and Testing the Design Using Agilex™ 5 E-Series 065B Modular Development Kit Connecter with Bitec Rev 8 Daughter Card
1.5.2. Compiling and Testing the Design Using Agilex™ 5 E-Series 065B Modular Development Kit Connector with No FMC Mode
The Modular Development Kit has DisplayPort connectors on its carrier board, supporting up to UHBR13.5 data rates. If you select the development kit connector during example generation, compile and run a demonstration test on the hardware example design.
Modular Development Kit Connector with No FMC Mode
- Ensure hardware design example generation is complete.
- Launch the Quartus® Prime Pro Edition software and open <project>/quartus/agi_dp_demo.qpf.
- On the Processing menu, click Start Compilation.
- Confirm successful compilation by verifying that the IP generates the bitstream file (.sof) and meets the timing requirements.
- Connect the DisplayPort TX connector on the carrier board to a DisplayPort sink device, such as a video analyzer or a PC monitor.
Related Information