1. GTS HDMI IP Quick Reference
2. About the GTS HDMI IP
3. GTS HDMI IP Getting Started
4. GTS HDMI IP Hardware Design Examples
5. HDMI Source
6. HDMI Sink
7. Transceiver Handling (HDMI Wrapper = HDMI and Transceiver)
8. GTS HDMI IP Parameters
9. HDMI Simulation Example
10. GTS HDMI IP User Guide Archives
11. Document Revision History for the GTS HDMI IP User Guide
5.1.1. Source Scrambler, TMDS/TERC4 Encoder
5.1.2. Source Video Resampler
5.1.3. Source Window of Opportunity Generator
5.1.4. Source Auxiliary Packet Encoder
5.1.5. Source Auxiliary Packet Generators
5.1.6. Source Auxiliary Data Path Multiplexers
5.1.7. Source Auxiliary Control Port
5.1.8. Source Audio Encoder
5.1.9. TX Core-PHY Interface
5.1.10. I2C Controller
6.1.1. Sink Word Alignment and Channel Deskew
6.1.2. Sink Descrambler, TMDS/TERC4 Decoder
6.1.3. Sink Auxiliary Decoder
6.1.4. Sink Auxiliary Packet Capture
6.1.5. Sink Video Resampler
6.1.6. Sink Auxiliary Data Port
6.1.7. Sink Audio Decoder
6.1.8. Status and Control Data Channel (SCDC) Interface
6.1.9. RX Core-PHY Interface
6.1.10. I2C Target
6.1.11. I2C and EDID RAM Blocks
5.1.9.1. TX Oversampler
The TX oversampler transmits data by repeating each bit of the input word a given number of times and constructs the output words.
There are four possible oversampling factors: 2, 3, 4, and 5. The oversampler assumes that the input word is only valid for the number of clock cycles defined by the oversampling factor. The oversampler is enabled when the outgoing data stream is determined to be below the TX transceiver minimum data rate. The oversampler then reads the DCFIFO once every number of clock cycles determined by the oversampling factor.