Intel® Stratix® 10 Configuration User Guide

ID 683762
Date 1/10/2022
Public

A newer version of this document is available. Customers should click here to go to the newest version.

Document Table of Contents

2.5.3.1.3. CONF_DONE and INIT_DONE

For Intel® Stratix® 10 devices, both CONF_DONE and INIT_DONE share multiplexed SDM_IO pins.

Previous device families implement the CONF_DONE and INIT_DONE pins as open drains with a weak internal pull-up. The CONF_DONE signal indicates that the configuration bitstream is received successfully. The INIT_DONE pin indicates that the device operates within the design.

In the current implementation, you cannot wire an Intel® Stratix® 10 CONF_DONE or INIT_DONE signal with the nSTATUS signal from previous device families. Otherwise, CONF_DONE and INIT_DONE behave as these signals behaved in earlier device families. If you assign CONF_DONE and INIT_DONE to SDM_IO16 and SDM_IO0, weak internal pull-downs pull these pins low at power-on reset. Ensure you specify these pins in the Intel® Quartus® Prime Software or in the Intel® Quartus® Prime settings file, (.qsf). CONF_DONE and INIT_DONE are low prior to and during configuration. CONF_DONE asserts when the device finishes receiving configuration data. INIT_DONE asserts when the device enters user mode.

Note: The entire device does not enter user mode simultaneously. Intel recommends that you follow the Including the Reset Release Intel FPGA IP in Your Design to hold your application logic in the reset state until the entire FPGA fabric is in user mode.

CONF_DONE and INIT_DONE are optional signals. You can use these pins for other functions that the Intel® Quartus® Prime Pro Edition Device and Pin Options menu defines.