User Guide

Intel® VTune™ Profiler User Guide

ID 766319
Date 7/13/2023
Public

A newer version of this document is available. Customers should click here to go to the newest version.

Document Table of Contents

Manage Analysis Duration from Command Line

Manage analysis duration for best results on short-running targets, or to minimize collection overhead on longer-running targets.

Use the vtune command interface to minimize duration while optimizing the analysis process.

Use Default Duration

Intel® VTune™ Profiler provides predefined general analysis types to keep overhead to a reasonable level. The option reference topic for the collect action identifies analysis types that are recommended as starting points; and points out some more advanced analysis types that have higher overhead.

NOTE:

To view all the analysis types that are available for your processor, use the command line help:

vtune -help collect

Adjust Collection Duration to Application

The sampling interval determines how much data is collected. The default sampling interval is short, which is appropriate for targets that complete in 1 - 15 minutes.

If your target runs shorter or longer than this, use the target-duration-type action-option to set the appropriate duration type, which adjusts the sampling interval.

  • If the target takes less than 1 minute to run, specify veryshort.

  • If the target takes 15 minutes to 3 hours to run, specify medium.

  • If the target takes over 3 hours, specify long.

NOTE:

For hardware event-based analysis types, a multiplier applies to the configured Sample After value.

Example

Perform a Hotspots analysis in the user-mode sampling mode using a medium sampling interval that is appropriate for targets with a duration of 15 minutes to 3 hours.

vtune -collect hotspots -target-duration-type medium -- myApp

Manually Interrupt and Restart Analysis

To pause an analysis manually, open a new terminal and use the command action with the pause argument, being sure to specify the result directory. The target process continues to run, but data collection is paused.

vtune -command pause -result-dir results/r002hs

To resume analysis, use the command action with the resume argument.

vtune -command resume -r results/r002hs

To stop analysis altogether, use the command action with the stop argument. Once analysis is stopped, it cannot be resumed.

vtune -command stop -r results/r002hs

Configure Collection Duration

VTune Profiler offers other ways to limit the analysis process. To stop analysis at a specified time after initiating target execution, use the duration option.

vtune -collect <analysis_type> -duration=<value> -- <target>

where

  • <analysis_type> is the type of analysis to run

  • <value> is the duration in seconds

  • <target> is the target to analyze

NOTE:

To start the analysis in the paused mode or pause the collection during the analysis, refer to Pause Collection from the Command Line section.

Examples

Example 1: Ending analysis after specified time

Start a Hotspots analysis of myApplication and end analysis after 60 seconds.

vtune -collect hotspots -duration=60 -- /home/test/myApplication

Example 2: Running an unlimited duration analysis

Run an unlimited duration Hotspots analysis, which will run until you stop it.

vtune -collect hotspots -duration=unlimited -result-dir results/r002hs

See Also