Hard Processor System Component Reference Manual: Agilex™ 5 SoCs
ID
813752
Date
8/15/2025
Public
1. Introduction to the Agilex™ 5 Hard Processor System Component
2. Configuring the Agilex™ 5 Hard Processor System Component
3. Simulating the Agilex™ 5 HPS Component
4. Simulating the Agilex™ 5 HPS bridges (H2F, LWH2F, F2SDRAM, F2H)
5. Design Guidelines
6. Document Revision History for the Hard Processor System Component Reference Manual Agilex™ 5 SoCs
2.1. Parameterizing the HPS Component
2.2. HPS-FPGA Interfaces
2.3. SDRAM
2.4. HPS Clocks, Reset, Power
2.5. I/O Delays
2.6. Pin Mux and Peripherals
2.7. Generating and Compiling the HPS Component
2.8. Using the Address Span Extender Component
2.9. Configuring the Agilex™ 5 Hard Processor System Component Revision History
2.2.1.1. Enable MPU Standby and Event Signals
2.2.1.2. Enable General Purpose Signals
2.2.1.3. Enable Debug APB* Interface
2.2.1.4. Enable System Trace Macrocell (STM) Hardware Events
2.2.1.5. Enable SWJ-DP JTAG Interface
2.2.1.6. Enable FPGA Cross Trigger Interface
2.2.1.7. Enable AMBA* Trace Bus (ATB)
2.3.1. Configurations for HPS IP
2.3.2. Configurations for HPS EMIF IP
2.3.3. Graphical Connections of HPS to HPS-EMIF
2.3.4. Configuration when using ECC
2.3.5. Configuration of HPS EMIF Calibration Settings
2.3.6. Supported Memory Protocols Among Device Families
2.3.7. IO96 Bank and Lane Usage for HPS EMIF
2.3.8. Quartus Report of I/O Bank Usage
2.3.9. Debugging with the External Memory Interface Debug Toolkit
3.1.1. Setting Up the HPS Component for Simulation
The following steps outline how to set up the HPS component for simulation.
- Add the HPS component from the Platform Designer Component Library.
- Configure the component based on your application needs by selecting or deselecting the HPS/FPGA interfaces.
Note: HPS only simulates the AXI* 4 bridge interfaces.
- Connect the appropriate HPS interfaces to other components in the system. For example, connect the FPGA-to-SDRAM AXI* 4 subordinate interface to a compatible AXI* or Avalon®-MM manager interface in another component in the system.
Note: You can test, compile, and elaboration file (elab) without connecting anything to the HPS.
- Click Generate HDL and select desired simulation options in the simulation section before clicking Generate in the pop-up window.
Related Information