R-Tile Avalon® Streaming Intel® FPGA IP for PCI Express* User Guide

ID 683501
Date 10/02/2023
Public

A newer version of this document is available. Customers should click here to go to the newest version.

Document Table of Contents

6.3. Signal Tap Logic Analyzer

You can use the Signal Tap Logic Analyzer to monitor the top-level signals below from the R-Tile Avalon-ST IP for PCIe as an additional debug tool for PCIe issues.

Table 111.  Top-Level Signals to be Monitored for Debug Purposes
Signal Description Expected Value for Successful Link-up
ninit_done

A "1" on this active-low signal indicates that the FPGA device is not yet fully configured. A "0" indicates the device has been configured and is in normal operating mode. You need to instantiate the Reset Release IP and connect the output of that IP to ninit_done.

1'b0
pin_perst_n_o This output signal to the FPGA fabric indicates if PERST# is asserted. 1'b1
pX_reset_status_n_o

This active-low signal is held low until pin_perst_n has been deasserted and the PCIe Hard IP has come out of reset.

This signal is synchronous to coreclkout_hip. Traffic between the user logic in the FPGA core and the IP can start when pX_reset_status_n_o is asserted high.

1'b1
pX_link_up_o When asserted, this signal indicates the link is up at the Physical Layer. 1'b1
pX_dl_up_o When asserted, this signal indicates the Data link (DL) Layer is active. 1'b1
pX_ltssm_state_delay_o[5:0] Indicates the LTSSM state. Note that there is a time difference between the actual link state at the physical level and the time it takes to reflect its value on this signal. 6'h11 (L0)