Intel® FPGA Download Cable User Guide

ID 683076
Date 3/11/2020
Public
Download
Document Table of Contents

B. Revision History

Table 11.  Revision History for the Intel® FPGA Download Cable User Guide
Document Version Changes
2020.03.11

Updated Intel® FPGA Download Cable Block Diagram in Block Diagram and Dimension

2019.10.23
2019.06.11

Updated Block Diagram of the Intel® FPGA Download Cable to show correct position of Pin 1 in the section Block Diagram and Dimension

2019.04.12
  • Corrected the unit in the Recommended Operating Conditions and DC Operating Conditions for Intel® FPGA Download Cable Rev. C tables.
  • Added how to install USB drivers for Red Hat Enterprise systems.
Date Version Changes
October 2016 2016.10.31
  • Changed instances of Quartus II to Quartus Prime.
  • Changed instances of USB-Blaster Download cable II to Intel® FPGA Download Cable.
  • Updated document template.
August 2015 2015.08.20
  • Removed PROC_RST signal which is not supported in USB-Blaster.
May 2015 2015.05.04
  • Updated the document organization.
  • Added new devices in the following sections: Supported Devices and Host Systems and Power Requirements.
  • Updated the procedure on driver installation for Windows.
  • Revised the pin width of the female plug.
April 2009 2.5
  • Updated “Supported Devices” section.
  • Updated “Software Requirements”.
  • Deleted handnote in “Installing the USB-Blaster Driver on Windows Vista Systems”.
  • Updated Table 2–1.
  • Added a handnote in “Circuit Board Header Connection”.
  • Updated Table 2–5.
April 2008 2.4
  • Added “Statement of China-RoHS Compliance”.
  • Added Table 2–8.
  • Added “Installing the USB-Blaster Driver on Windows Vista Systems”.
May 2007 2.3
  • Updated “Introduction”.
  • Added warning note about USB-Blaster cable in “Hardware Setup” section.
  • Added information on Linux setup in “Installing the USB-Blaster Driver on Linux” section.
  • Added feetpara note on driver information just before the “Setting Up the USB-Blaster Hardware in the Quartus II Software” section.
  • Updated USB-Blaster installation procedure for QII 6.1 (32-bit or 64-bit) in “Installing the USB-Blaster Driver on Windows 2000 and Windows XP Systems” section.
March 2007 2.2
  • Update to “Installing the USB-Blaster Driver on Windows 2000 and Windows XP Systems” section.
July 2006 2.1 Minor update to Chapter 2, USB-Blaster Specifications.
June 2006 2.0
  • Updated Figure 2–1, Table 2–1, and Table 2–7.
  • Added Table 2–6.
December 2004 1.2 Update to conditions in Table 2–2.
November 2004 1.1 Minor update.
July 2004 1.0 Initial release.

Did you find the information on this page useful?

Characters remaining:

Feedback Message