4.8. Hot Plug Interface (RP Only)
Hot Plug support means that the device can be added to or removed from a system during runtime. The Hot Plug Interface in the P-Tile IP for PCIe allows an Intel FPGA with this IP to safely provide this capability.
This section describes the signals reported by the on-board hot plug components in the Downstream Port. This interface is available only if the Slot Status Register of the PCI Express Capability Structure is enabled.
|Signal Name||Direction||Description||Clock Domain||EP/RP/BP|
|sys_atten_button_pressed_i||I||Attention Button Pressed. Indicates that the system attention button was pressed, and sets the Attention Button Pressed bit in the Slot Status Register.||coreclkout_hip||RP|
|sys_pwr_fault_det_i||I||Power Fault Detected. Indicates the power controller detected a power fault at this slot.||coreclkout_hip||RP|
|sys_mrl_sensor_chged_i||I||MRL Sensor Changed. Indicates that the state of the MRL sensor has changed.||coreclkout_hip||RP|
|sys_pre_det_chged_i||I||Presence Detect Changed. Indicates that the state of the card presence detector has changed.||coreclkout_hip||RP|
|sys_cmd_cpled_int_i||I||Command Completed Interrupt. Indicates that the Hot Plug controller completed a command.||coreclkout_hip||RP|
Indicates whether or not a card is present in the slot.
0 : slot is empty.
1 : card is present in the slot.
MRL Sensor State. Indicates the state of the manually operated retention latch (MRL) sensor.
0 : MRL is closed.
1 : MRL is open.
|sys_eml_interlock_engaged_i||I||Indicates whether the system electromechanical interlock is engaged, and controls the state of the electromechanical interlock status bit in the Slot Status Register.||coreclkout_hip||RP|