2.1.1.1. Occasional equalization timeout or PCIe link training failure to achieve expected link speed during speed change, hot reset, and link disable
2.1.1.2. Occasional receiver error recorded in the Advanced Error Reporting (AER) register during speed change and power management procedures
2.1.1.3. Both ERR_COR and ERR_FATAL messages are sent when TLP with ECRC error is received
Description
Workaround
Status
2.1.1.4. Multiple error messages are generated by the multifunction device when a non-function-specific error occurs
2.1.1.5. Transmission of all Ethernet frames is suspended upon reception of PAUSE frame request from External link partner
2.1.1.6. Reduced Tx performance on GTS Ethernet FPGA Hard IP for 25GE line rate
2.1.2.1. The USB 3.1 controller has a spillover condition during IN transfers for bulk endpoint which causes a DBE issue for the ISOC-IN Endpoint
2.1.2.2. USB 3.1 Controller Device Drops eSS ISOC Data if the ITP Delta Value is Greater than 63 units
2.1.2.3. The USB 3.1 controller has a possible glitch on the clock output during U3 to U0 power state transition
2.1.1.3. Both ERR_COR and ERR_FATAL messages are sent when TLP with ECRC error is received
Description
In the GTS AXI Streaming IP for PCIe, if the ECRC Error Severity field of the Uncorrectable Error Severity register is set, both ERR_COR and ERR_FATAL messages are sent when a TLP with ECRC error is received. The ECRC error is reported as correctable as well as fatal instead of fatal when the ECRC error severity is fatal. The Advisory Non-Fatal Error Status field of the Correctable Error Status register is set incorrectly. However, masking the Advisory Non-Fatal Error does not prevent the generation of ERR_COR message. In this situation, it is safe to clear the Advisory Non-Fatal Error and ignore the ERR_COR message.
Workaround
None.
Status
| Devices Affected | Planned Fix |
|---|---|
|
None |