AN 964: Signal Tap Tutorial for Intel Agilex® 7 Partial Reconfiguration Designs

ID 710463
Date 10/02/2023
Public
Document Table of Contents

2.6. Step 6: Programming the FPGA Device

Before you begin:
  1. Connect the power supply to the Intel Agilex® 7 F-Series or M-Series FPGA development board.
  2. Connect the USB Blaster cable between your PC USB port and the USB Blaster port on the development board.
Note: This tutorial utilizes the Intel Agilex® 7 F-Series or M-Series FPGA development board on the bench, outside of the PCIe* slot in your host machine.
To program the design on the board:
  1. In the Intel® Quartus® Prime software, click Tools > Programmer.
  2. In the Programmer, click Hardware Setup and select USB-Blaster
  3. Click Auto Detect and select the appropriate Intel Agilex® 7 device for your development board.
  4. Click OK. The Intel® Quartus® Prime software detects and updates the Programmer with the FPGA devices on the board.
  5. Select the appropriate Intel Agilex® 7 device for your development board and click Change File and load the blinking_led.sof file.
  6. Enable Program/Configure for blinking_led.sof file.
  7. Click Start and wait for the progress bar to reach 100%.
  8. To program the PR persona that you want to debug, right-click the blinking_led.sof file in the Programmer, and click Add PR Programming File.
  9. Select the blinking_led_slow.pr_partition.rbf file.
  10. Disable Program/Configure for the blinking_led.sof file.
  11. Enable Program/Configure for blinking_led_slow.pr_partition.rbf file and click Start.
  12. On the board, verify that two of the LEDs are blinking slower than the other two.