L-Tile and H-Tile Avalon® Memory-mapped+ Intel® FPGA IP for PCI Express* User Guide
ID
683527
Date
9/13/2024
Public
1. Introduction
2. Quick Start Guide
3. Block and Interface Descriptions
4. Parameters
5. Designing with the IP Core
6. Registers
7. Design Example and Testbench
8. Document Revision History for Intel® L- and H-tile Avalon® Memory-mapped+ IP for PCI Express* User Guide
A. Avalon-MM IP Variants Comparison
B. Root Port BFM
C. BFM Procedures and Functions
D. Troubleshooting and Observing the Link Status
E. Root Port Enumeration
2.1. Design Components
2.2. Directory Structure
2.3. Generating the Design Example
2.4. Simulating the Design Example
2.5. Compiling the Design Example and Programming the Device
2.6. Installing the Linux Kernel Driver
2.7. Running the Design Example Application
2.8. Ensuring the Design Example Meets Timing Requirements
6.1.1. Register Access Definitions
6.1.2. PCI Configuration Header Registers
6.1.3. PCI Express Capability Structures
6.1.4. Intel Defined VSEC Capability Header
6.1.5. Uncorrectable Internal Error Status Register
6.1.6. Uncorrectable Internal Error Mask Register
6.1.7. Correctable Internal Error Status Register
6.1.8. Correctable Internal Error Mask Register
C.1. ebfm_barwr Procedure
C.2. ebfm_barwr_imm Procedure
C.3. ebfm_barrd_wait Procedure
C.4. ebfm_barrd_nowt Procedure
C.5. ebfm_cfgwr_imm_wait Procedure
C.6. ebfm_cfgwr_imm_nowt Procedure
C.7. ebfm_cfgrd_wait Procedure
C.8. ebfm_cfgrd_nowt Procedure
C.9. BFM Configuration Procedures
C.10. BFM Shared Memory Access Procedures
C.11. BFM Log and Message Procedures
C.12. Verilog HDL Formatting Functions
3.2.1.1.3. Read Data Mover Status Avalon-ST Source
Signal Name | Direction | Description |
---|---|---|
rddm_tx_data_o[18+<PFNUM_WIDTH>-1:18] | Output | These bits contain the function number. |
rddm_tx_data_o[17:0] | Output | [17:16] : reserved
[15] : reserved
Note: When the Enable Completion Checking option in the Avalon® -MM Settings tab of the GUI is On, this bit becomes the completion timeout error flag.
[14:12] : application specific [11:9] : reserved [8] : priority [7:0] : descriptor ID |
rddm_tx_valid_o | Output | Valid status signal. |
This interface does not have a ready input. The application logic must always be ready to receive status information for any descriptor that it has sent to the Read Data Mover.
The Read Data Mover copies over the application specific bits in the rddm_tx_data_o bus from the corresponding descriptor. A set priority bit indicates that the descriptor is from the priority descriptor sink.
A status word is output on this interface when the processing of a descriptor has completed, including the reception of all completions for all memory read requests.