E-Tile JESD204C Intel® Stratix® 10 FPGA IP Design Example User Guide

Download PDF
ID 683357
Date 10/02/2023
Public
Document Table of Contents
Document Table of Contents x
1. About the JESD204C Intel® Stratix® 10 FPGA IP Design Example User Guide 2. JESD204C Intel® FPGA IP Design Example Quick Start Guide 3. Detailed Description for the JESD204C Design Example 4. E-Tile JESD204C Intel® Stratix® 10 FPGA IP Design Example User Guide Archives 5. Document Revision History for the E-Tile JESD204C Intel® Stratix® 10 FPGA IP Design Example User Guide
2. JESD204C Intel® FPGA IP Design Example Quick Start Guide x
2.1. Design Example Block Diagram 2.2. Hardware and Software Requirements 2.3. Generating the Design 2.4. Compiling and Simulating the Design 2.5. Compiling and Testing the Design
2.3. Generating the Design x
2.3.1. Design Example Parameters 2.3.2. Directory Structure
3. Detailed Description for the JESD204C Design Example x
3.1. System Components 3.2. JESD204C Design Example Clock and Reset 3.3. JESD204C Design Example Signals 3.4. JESD204C Design Example Control Registers 3.5. Hardware Test for System Console Control Design Example
3.1. System Components x
3.1.1. JTAG to Avalon® Master Bridge 3.1.2. Parallel I/O (PIO) Core 3.1.3. SPI Master 3.1.4. SYSREF Generator 3.1.5. Pattern Generator and Checker
3.5. Hardware Test for System Console Control Design Example x
3.5.1. Board Connectivity
1. About the JESD204C Intel® Stratix® 10 FPGA IP Design Example User Guide
2. JESD204C Intel® FPGA IP Design Example Quick Start Guide
3. Detailed Description for the JESD204C Design Example
4. E-Tile JESD204C Intel® Stratix® 10 FPGA IP Design Example User Guide Archives
5. Document Revision History for the E-Tile JESD204C Intel® Stratix® 10 FPGA IP Design Example User Guide

2.4. Compiling and Simulating the Design

The design example testbench simulates your generated design.

To simulate the design, perform the following steps:

  1. Change the working directory to <example_design_directory>/simulation/<Simulator>.
  2. In the command line, run the simulation script. The table below shows the commands to run the supported simulators.
    Simulator Command

    ModelSim*

    QuestaSim*

    		vsim -do modelsim_sim.tcl
    vsim -c -do modelsim_sim.tcl (without ModelSim* or QuestaSim* GUI)
    VCS* sh vcs_sim.sh
    VCS* MX sh vcsmx_sim.sh
    Xcelium* Parallel sh xcelium_sim.sh
    The simulation ends with messages that indicate whether the run was successful or not.
    Figure 4. Successful SimulationThe average simulation run time is about 30 minutes.
Level Two Title