Intel® Quartus® Prime Pro Edition User Guide: Design Recommendations
ID
683082
Date
3/28/2022
Public
A newer version of this document is available. Customers should click here to go to the newest version.
1.1. Using Provided HDL Templates
1.2. Instantiating IP Cores in HDL
1.3. Inferring Multipliers and DSP Functions
1.4. Inferring Memory Functions from HDL Code
1.5. Register and Latch Coding Guidelines
1.6. General Coding Guidelines
1.7. Designing with Low-Level Primitives
1.8. Recommended HDL Coding Styles Revision History
1.4.1.1. Use Synchronous Memory Blocks
1.4.1.2. Avoid Unsupported Reset and Control Conditions
1.4.1.3. Check Read-During-Write Behavior
1.4.1.4. Controlling RAM Inference and Implementation
1.4.1.5. Single-Clock Synchronous RAM with Old Data Read-During-Write Behavior
1.4.1.6. Single-Clock Synchronous RAM with New Data Read-During-Write Behavior
1.4.1.7. Simple Dual-Port, Dual-Clock Synchronous RAM
1.4.1.8. True Dual-Port Synchronous RAM
1.4.1.9. Mixed-Width Dual-Port RAM
1.4.1.10. RAM with Byte-Enable Signals
1.4.1.11. Specifying Initial Memory Contents at Power-Up
1.6.6.1. If Performance is Important, Optimize for Speed
1.6.6.2. Use Separate CRC Blocks Instead of Cascaded Stages
1.6.6.3. Use Separate CRC Blocks Instead of Allowing Blocks to Merge
1.6.6.4. Take Advantage of Latency if Available
1.6.6.5. Save Power by Disabling CRC Blocks When Not in Use
1.6.6.6. Initialize the Device with the Synchronous Load (sload) Signal
3.4.1. Apply Complete System-Centric Timing Constraints for the Timing Analyzer
3.4.2. Force the Identification of Synchronization Registers
3.4.3. Set the Synchronizer Data Toggle Rate
3.4.4. Optimize Metastability During Fitting
3.4.5. Increase the Length of Synchronizers to Protect and Optimize
3.4.6. Increase the Number of Stages Used in Synchronizers
3.4.7. Select a Faster Speed Grade Device
2.5.3. Running Design Assistant in Analysis Mode
You can launch Design Assistant in analysis mode directly from the Timing Analyzer or Chip Planner to rapidly run the specific rule checks that relate to those tools. For example, when you launch Design Assistant from the Chip Planner, Design Assistant is preset to check only a subset of the FLP (floorplanning) Design Assistant rules.
Similarly, when you launch Design Assistant from the Timing Analyzer, Design Assistant is preset to check only a subset of rules that are helpful during timing analysis. You can cross-probe to the Timing Analyzer and design visualization tools to determine the root cause of violations.
When you enable or specify parameters for a rule check in analysis mode, those specifications do not apply to running Design Assistant in compilation mode. The rule settings for analysis mode are independent from the rule settings in compilation mode.