MasterBlaster™ USB Driver Information for Windows 98

Windows will prompt you to install the MasterBlaster Universal Serial Bus (USB) cable driver the first time the MasterBlaster programmer is plugged in.

Quartus® II - Driver Installation

When you plug in the MasterBlaster USB cable, Windows 98 will automatically recognize it and start the Add New Hardware wizard.

  1. Click Next in the Add New Hardware Wizard window.
  2. Click Next again.
  3. Choose Display a list of all the drivers in a specific location and click Next.
  4. Choose Universal Serial Bus controller from the list of devices and click Next.
  5. Click the Have Disk... button.
  6. Click Browse in the Install From Disk window.
  7. Browse to the <Path to Quartus II software>\drivers directory and click OK.
  8. Click OK in the Install From Disk window.
  9. Choose MasterBlaster in the Models list and click Next.
  10. Click Next to install the driver.
  11. Click Finish.
  12. Set up programming hardware in the Quartus II software to complete your installation.

MAX+PLUS® II 10.0 and later - Driver Installation

When you plug in the MasterBlaster USB cable, Windows 98 will automatically recognize it and start the Add New Hardware Wizard.

  1. Click Next in the Add New Hardware Wizard window.
  2. Click Next again.
  3. Choose Display a list of all the drivers in a specific location and click Next.
  4. Choose Universal Serial Bus controller from the list of devices and click Next.
  5. Click the Have Disk... button.
  6. Click Browse in the Install From Disk window.
  7. Browse to the <Path to MAX+PLUS II software>\Drivers\i386 directory and click OK.
  8. Click OK in the Install From Disk window.
  9. Choose MasterBlaster in the Models list and click Next.
  10. Click Next to install the driver.
  11. Click Finish.
  12. Set up programming hardware in the MAX+PLUS II software to complete your installation.

MAX+PLUS II software version 9.64 and earlier does not support the MasterBlaster cable USB interface.

Related Information

Solution for the following error:

Why isn't my MasterBlaster auto-detected after plugging it into the USB port? ›