Article ID: 000075601 Content Type: Troubleshooting Last Reviewed: 06/30/2014

Why don't I see an difference in simulation results when I change the Tx drive strength settings of the IBIS-AMI transceiver models?

Environment

    Simulation
BUILT IN - ARTICLE INTRO SECOND COMPONENT
Description

You will not see any difference in drive strength of Altera® Tx IBIS-AMI models if only the Ivod IBIS-AMI parameter is changed. You also need to change the appropriate selected analog IBIS-AMI model. The following document details how to change the Tx drive strength.

IBIS-AMI Drive Strength Process (Right-click, Save as)

Related Products

This article applies to 7 products

Stratix® V E FPGA
Stratix® V GS FPGA
Stratix® V GT FPGA
Stratix® IV GX FPGA
Stratix® V GX FPGA
Stratix® V FPGAs
Stratix® IV GT FPGA

1

Need more help?

Contact support

Disclaimer

1

All postings and use of the content on this site are subject to Intel.com Terms of Use.