AN 981: Using Generic QSPI Flash on SDM Devices

Download
ID 778053
Date 6/26/2023
Public
Document Table of Contents
Document Table of Contents x
1. Introduction 2. Overview 3. Requirements 4. Implementation Flow 5. Debugging QSPI Flash Device using QSPI Debugger 6. Document Revision History for AN 981: Using Generic QSPI Flash on SDM Devices
3. Requirements x
3.1. QPI Mode (4-4-4 protocol) 3.2. Sector Erase Size 3.3. Maximum QSPI Clock 3.4. QSPI Flash Device Reset Pin 3.5. QSPI Page Program Opcode 3.6. SFDP Parameters
4. Implementation Flow x
4.1. Generating Programming Files using Programming File Generator 4.2. Programming .jic files into QSPI Flash Device 4.3. Hard Processor System (HPS) Support
1. Introduction
2. Overview
3. Requirements
4. Implementation Flow
5. Debugging QSPI Flash Device using QSPI Debugger
6. Document Revision History for AN 981: Using Generic QSPI Flash on SDM Devices

3. Requirements

This section explains what is needed in a QSPI flash device in order to meet the SDM firmware requirements.


Section Content
QPI Mode (4-4-4 protocol)
Sector Erase Size
Maximum QSPI Clock
QSPI Flash Device Reset Pin
QSPI Page Program Opcode
SFDP Parameters

Level Two Title

Did you find the information on this page useful?

Characters remaining:

Feedback Message