Using Containers with Eclipse*
Use the Samples Browser to Create an Eclipse Project
If you have installed the Intel® oneAPI IoT Toolkit, you can use the Samples Browser integrated into the Eclipse IDE to create a project based on Intel samples.
Run Eclipse and select Intel > Browse Intel oneAPI Samples…
The Sample Browser dialog window will be displayed.
Expand the Intel® oneAPI IoT Toolkit tree and select Hello IoT World. Click Finish to create a project based on the sample.
Configure Project Properties
- Make sure you've followed the steps described on the Using Containers page to download the Docker image.
- Open the Project Properties by right clicking Project > Properties.
- In Properties select C/C++ Build > Settings, and open the Container Settings tab to set the following:
- Check Build Inside Docker Image.
- Select the docker image to use. If there are no images listed, verify that Docker is enabled for non-root users. Alternatively, you can run Eclipse with sudo.
- Apply and close the settings.
Compile the Application
- Click the Build Icon .
- Confirm that the console prints "Running in image..."
- Create a Run Configuration with Run > Run Configurations.
- Create a new C/C++ Container Launcher.
Select the Container tab and make sure the Image is set to the correct Docker image. To enable GPU in the container, add /dev/dri in the Required Host Directories and check Run in Privileged Mode.
- Click the Run icon.
- Confirm that the console prints Running in image...