Article ID: 000077736 Content Type: Troubleshooting Last Reviewed: 09/11/2012

Can the Stratix II GX transceiver Word Aligner be bypassed ?

Environment

BUILT IN - ARTICLE INTRO SECOND COMPONENT
Description

The Stratix® II GX Word Aligner cannot be bypassed and must be used.

 

However, you can use the rx_enapatternalign port to set the word alignment to not align to the pattern or use the manual bit-slipping mode in the MegaWizard and tie rx_bitslip port to GND.

Related Products

This article applies to 1 products

Stratix® II GX FPGA