Article ID: 000075647 Content Type: Troubleshooting Last Reviewed: 02/13/2006

What should I do with the DCLK pin on a FLEX® 10K or FLEX 8000 device if I am using the Passive Parallel Asynchronous (PPA) configuration mode?

Environment

BUILT IN - ARTICLE INTRO SECOND COMPONENT
Description The DCLK pin should be pulled high or low using a 1-Kohm pull-up resistor to prevent the unused configuration pin from floating.

Related Products

This article applies to 1 products

Intel® Programmable Devices

Need more help?

Contact support

Disclaimer

1

All postings and use of the content on this site are subject to Intel.com Terms of Use.