Article ID: 000080239 Content Type: Error Messages Last Reviewed: 09/11/2012

Warning: On-chip termination control block "name" parameter enable_parallel_termination changed to true

Environment

  • Quartus® II Subscription Edition
    • BUILT IN - ARTICLE INTRO SECOND COMPONENT
    Description

    You may see this warning when you compile a design using DDR3 SDRAM Controller with UniPhy in Quartus® II software version 11.1SP1 or earlier. This warning can safely be ignored since parallel termination is expected.

    The warning is scheduled to be fixed in a future version of Quartus II software.

    Related Products

    This article applies to 1 products

    Intel® Programmable Devices

    Need more help?

    Contact support

    Disclaimer

    1

    All postings and use of the content on this site are subject to Intel.com Terms of Use.