Low Latency Ethernet 10G MAC IP Design Example User Guide: Agilex™ 3 and Agilex™ 5 FPGAs and SoCs

ID 813665
Date 8/04/2025
Public
Document Table of Contents

9.3.1. Design Components

Table 26.  Design Components
Component Description
LL 10GbE MAC

The Low Latency Ethernet 10G MAC IP with the following configuration:

  • Speed: 10M/100M/1G/2.5G/5G/10G (USXGMII)
  • Datapath options: TX & RX
  • Enable ECC on memory blocks: Not selected
  • Enable preamble pass-through mode: Not selected
  • Enable priority-based flow control(PFC): Not selected
  • Enable supplementary address: Selected
  • Enable statistics collection: Selected
  • Statistics counters: Memory-based
  • TX and RX datapath Reset/Default To Enable: Selected
  • Use legacy Avalon Memory-Mapped Interface: Not selected
  • Use legacy Avalon Streaming Interface: Selected
PHY The 1G/2.5G/5G/10G Multirate Ethernet PHY IP with the following configuration:
  • Connect to MGBASE-T PHY: Not selected
  • Connect to NBASE-T PHY: Selected
  • Speed: 10M/100M/1G/2.5G/5G/10G
  • Enable SGMII bridge: Not selected
  • Enabled IEEE 1588 Precision Time Protocol: Not selected
  • Enable GMII Adapter: Not selected
  • PHY ID (32 bit): NA
  • Default Mode: 10GbE
  • PMA Reference Frequency: 156.25 MHz
  • System PLL Frequency: 644.53125 MHz
Channel address decoder Decodes the addresses of the components in each Ethernet channel, such as PHY and LL 10GbE MAC.
Multi-channel address decoder Decodes the addresses of the components used by all channels.
Top address decoder Decodes the addresses of the top-level components, such as the Traffic Controller.
System PLL

Supports system PLL clocking mode for Direct PHY.