F-Tile Dynamic Reconfiguration Design Example User Guide

ID 710582
Date 4/11/2024
Public
Document Table of Contents

2.1.1. CPRI Multirate Design Example: Simulation Testbench

Figure 7. Simulation Testbench Block Diagram

The testbench program is controlling the testbench components via Avalon® memory-mapped interface access, status and control signals. The Avalon® memory-mapped interface arbiter is used to decode the Avalon® memory-mapped interface access from testbench program into multiple Avalon® memory-mapped interface slaves.

Simulation Flow for Design Example:
  1. Disable the Testbench packet round-trip measurement.
  2. Power up the CPRI PHY Multirate IP DUT based on profile 0 (24G RS-FEC).
  3. Initialize the testbench variables based on power-up profile. The variables are:
    • cpri_speed: To indicate the speed of the current profile.
    • enable_rsfec: To indicate whether RS-FEC is enabled or disabled for the current profile.
    • current_dr_profile: To indicate the ID of the current profile.
  4. Perform dynamic reconfiguration.
  5. Check the testbench error flag and determine whether testbench passed or failed. This error flag is set to 1 if there is any error after dynamic reconfiguration traffic tests.
For customization, you can modify the DR_NUM and DR_SEQ localparam to configure test flow. Profile ID is passed into Dynamic Reconfiguration IP to configure the intended dynamic reconfiguration task.
  • DR_NUM: Number of Dynamic Reconfiguration transition
  • DR_SEQ: Dynamic Reconfiguration sequence
For example, you want to achieve this Dynamic Reconfiguration sequence: 24G RS-FEC > 10G > 4.9G. The localparams changes are:
  • DR_NUM = 2
  • DR_SEQ = {DR_TO_4P9G, DR_TO_10G};
Default configuration for the design example:
localparam DR_TO_24G_RSFEC   = 4'h0;
localparam DR_TO_24G         = 4'h1;
localparam DR_TO_12G_RSFEC   = 4'h2;
localparam DR_TO_12G         = 4'h3;
localparam DR_TO_10G_RSFEC   = 4'h4;
localparam DR_TO_10G         = 4'h5;
localparam DR_TO_9P8G        = 4'h6;
localparam DR_TO_6G          = 4'h7;
localparam DR_TO_4P9G        = 4'h8;
localparam DR_TO_3G          = 4'h9;
localparam DR_TO_2P4G        = 4'ha;
localparam DR_TO_1G          = 4'hb;

localparam DR_NUM = 5;
localparam [3:0] DR_SEQ [DR_NUM-1 : 0] = {DR_TO_24G_RSFEC, DR_TO_2P4G, DR_TO_4P9G, DR_TO_9P8G, DR_TO_10G};