Article ID: 000091364 Content Type: Troubleshooting Last Reviewed: 01/10/2023

Why are the E-Tile Ethernet Toolkit and the P-Tile Debug Toolkit not visible in the Intel® Quartus® Prime Pro Edition Software version 22.2?

Environment

  • Intel® Quartus® Prime Pro Edition
  • E-tile Hard IP for Ethernet Intel® FPGA IP
  • BUILT IN - ARTICLE INTRO SECOND COMPONENT
    Description

    Due to a problem in the Intel® Quartus® Prime Pro Edition Software version 22.2, the E-Tile Ethernet Toolkit and the P-Tile Debug Toolkit are not visible when the target device is an OPN including the parameters AGF019/023 R25A FP. When targeting these OPNs, the TCL scripts for these toolkits will also fail to run from System Console after the “design_load” command.

    This issue only happens when the device being targeted is the Intel® Agilex™ FPGA Federal Information Processing Standards (FIPS) silicon but the bitstream has been compiled by the Intel® Quartus® Prime Pro Edition Software version 22.2 with a non-FIPS OPN.

    Resolution

    To work around this problem ensure that the device OPN in the Intel® Quartus® Prime Pro Edition Software version 22.2 is the Intel® Agilex™ FPGA Federal InFPGAformation Processing Standards (FIPS) silicon when using FIPS OPN devices in hardware.

    The ability to use the toolkits with a non-FIPS OPN bitstream on a FIPS OPN device is scheduled to be supported in a future release of the Intel® Quartus® Prime Pro Edition Software.

    Related Products

    This article applies to 1 products

    Intel® Agilex™ 7 FPGAs and SoC FPGAs F-Series

    Disclaimer

    1

    All postings and use of the content on this site are subject to Intel.com Terms of Use.