Article ID: 000086759 Content Type: Troubleshooting Last Reviewed: 02/09/2021

Does the Intel® Quartus® Prime Pro Edition software version 20.4 and earlier support single ended strobe for the PHY Lite for Parallel Interfaces Intel Agilex™ FPGA IP?

Environment

  • Intel® Quartus® Prime Pro Edition
  • PHY Lite for Parallel Interfaces Intel® Arria® 10 FPGA IP
  • BUILT IN - ARTICLE INTRO SECOND COMPONENT
    Description

    In the Intel® Quartus® Prime Pro Edition software version 20.4 and earlier, only the "Differential" strobes are supported even though the parameter editor of the PHY Lite for Parallel Interfaces Intel Agilex™ FPGA IP incorrectly shows that "Single ended" strobes are available under the "Strobe Configuration" setting of the "Group*" tab.

    Resolution

    This problem is fixed starting with the Intel® Quartus® Prime Pro Edition software version 21.1.

    Related Products

    This article applies to 1 products

    Intel® Agilex™ 7 FPGAs and SoC FPGAs

    Disclaimer

    1

    All postings and use of the content on this site are subject to Intel.com Terms of Use.