Article ID: 000079329 Content Type: Troubleshooting Last Reviewed: 09/11/2012

When trying to program an EPCS device with a JIC file using Quartus II software why do I get a "Flash Loader IP not loaded on device 1" error message?

Environment

BUILT IN - ARTICLE INTRO SECOND COMPONENT
Description

When trying to program an EPCS configuration device using Quartus® II software you may get the "Flash Loader IP not loaded on device 1" error message if the nCONFIG or nSTATUS pins are held low.

In some cases a microprocessor or a bad pull-up resistor can cause the signals to be held low causing Quartus II software to generate the "Flash Loader IP not loaded on device 1" error message.

This error message may also occur if the Serial Flash Loader (SFL) image does not exist in the FPGA.

Related Products

This article applies to 1 products

Intel® Programmable Devices

1

Need more help?

Contact support

Disclaimer

1

All postings and use of the content on this site are subject to Intel.com Terms of Use.