The Active Serial (AS) configuration control block in Arria® 10 and Cyclone® 10 GX is fixed to 10 dummy clock cycles and 4 byte addressing, therefore only certain Macronix flash devices are supported for these FPGAs in Quartus® Prime Software version 18.1.
To work around this problem, the following Macronix* flash devices can be used in Active Serial (x1 and x4) configuration mode:
Macronix |
Vendor |
Part |
Voltage |
Package |
Density |
OPN |
Macronix |
MX25L |
2.7V-3.6V |
16-SOP |
128Mb |
MX25L12833FMI-10G | |
256Mb |
MX25L25645GMI-08G | |||||
512Mb |
MX25L51245GMI-08G | |||||
MX25U |
1.65V-2.0V |
24-TFBGA |
256Mb |
MX25U25645GXDI54 | ||
512Mb |
MX25U51245GXDI54 | |||||
1Gb |
MX66U1G45GXDI54 | |||||
2Gb |
MX66U2G45GXRI54 |
Refer to the list below for Macronix flash devices supported by Arria® 10 and the Cyclone® 10 GX devices in Quartus® Prime Software version 18.1.
Vendor |
FPGA |
Part |
Voltage |
Package |
Density |
OPN |
Macronix |
Arria® 10 and Cyclone® 10 GX |
MX25U |
1.65V-2.0V |
24-TFBGA |
256Mb |
MX25U25645GXDI54 |
512Mb |
MX25U51245GXDI54 | |||||
1Gb |
MX66U1G45GXDI54 | |||||
2Gb |
MX66U2G45GXRI54 |