Skip To Main Content
Support Knowledge Base

Ethernet Management Port Module (EMP Module) to Remotely Manage the Intel® D50TNP Modules

Content Type: Install & Setup   |   Article ID: 000059210   |   Last Reviewed: 05/13/2021

You can remotely manage the Intel® D50TNP Modules with the optional Ethernet Management Port Module (EMP Module) (iPC – AXXFCEMP).

Your system may or may not come preconfigured with an Ethernet Management Port Module. This section provides instructions for the installation and removal of this accessory option. The EMP module is hot-swap capable and can be installed or removed without powering down the system or any of its modules. This procedure applies to all Intel® D50TNP chassis types.

  1. If present, remove the EMP blank from the back of the server chassis by pulling it out from the chassis as shown below:

    example image

    Removing the Filler Blank

  2. Install the EMP module by sliding it into the open EMP bay until it locks into place (see Letter A):

    example image

    Installing the EMP Module

Related Products

This article applies to 9 products.
Intel® Server D50TNP Family Intel® Compute Module D50TNP2U Family Intel® Compute Module D50TNP1U Family

Discontinued Products

Intel® Server System D50TNP2MHSVAC Management Module Intel® Server System D50TNP2MHSTAC Storage Module Intel® Server System D50TNP1MHCRAC Compute Module Intel® Server System D50TNP1MHEVAC Compute Module Intel® Server System D50TNP1MHCRLC Compute Module Intel® Server System D50TNP2MFALAC Acceleration Module

Need more help?

Contact support
Contact support