List of Messages |
CAUSE: The specified port of the specified DSP block output WYSIWYG primitive is not connected or is connected to GND. When a WYSIWYG DSP block output primitive is part of an output adder chain that uses saturation, it should saturate after the second level adder and after the chain adder.
ACTION: Either disconnect the specified WYSIWYG DSP block output primitive from the adder chain, or connect the specified port to VCC or to a dynamic signal.
Copyright© 2015 Altera Corporation. All rights reserved. ALTERA, ARRIA, CYCLONE, HARDCOPY, MAX, MEGACORE, NIOS, QUARTUS, STRATIX, and all other brands, unless noted otherwise, and/or trademarks of Altera Corporation in the U.S. and other countries.