List of Messages |
CAUSE: The specified ports of the specified DSP block multiplier WYSIWYG primitive and the specified DSP block output WYSIWYG primitive are not fed by the same signal source. When the OPERATION_MODE is set to DYNAMIC, the specified ports must be fed by the same signal source.
ACTION: If you are using an EDA tool, contact the technical support for the EDA tool regarding this message. For further assistance contact Altera Technical Support by creating a Service Request at www.altera.com/mysupport.
Copyright© 2015 Altera Corporation. All rights reserved. ALTERA, ARRIA, CYCLONE, HARDCOPY, MAX, MEGACORE, NIOS, QUARTUS, STRATIX, and all other brands, unless noted otherwise, and/or trademarks of Altera Corporation in the U.S. and other countries.