List of Messages |
CAUSE: The specified WYSIWYG primitive uses a fpin fast input port, but the fpin port is not connected to the register port of another WYSIWYG primitive. The WYSIWYG primitive may also be using a pterm5 or pxor port, which are not supported, or may be in non-parallel expander mode (that is, it may have the PEXP_MODE parameter set to OFF) but is using pterm (pterm0–pterm4) ports. The fpin input port must feed the register port of another WYSIWYG primitive. In addition, the pterm or pxor ports must not be used, and either the PEXP_MODE parameter must be set to ON, or the pterm (pterm0–pterm4) ports must not be used.
ACTION: If you are using an EDA tool, contact the technical support for the EDA tool regarding this message. For further assistance, contact Altera Technical Support by creating a Service Request at www.altera.com/mysupport.
Copyright© 2015 Altera Corporation. All rights reserved. ALTERA, ARRIA, CYCLONE, HARDCOPY, MAX, MEGACORE, NIOS, QUARTUS, STRATIX, and all other brands, unless noted otherwise, and/or trademarks of Altera Corporation in the U.S. and other countries.