List of Messages |
CAUSE: The specified WYSIWYG LCELL COMB primitive is not in extended LUT mode (that is, the EXTENDED_LUT parameter is set to OFF), but uses the datag LUT input port. The datag port must be used only in extended LUT mode. Either the EXTENDED_LUT parameter must be set to ON, or the datag port must be disconnected.
ACTION: If you are using an EDA tool, contact the technical support for the EDA tool regarding this message. For further assistance, contact Altera Technical Support by creating a Service Request at www.altera.com/mysupport.
Copyright© 2015 Altera Corporation. All rights reserved. ALTERA, ARRIA, CYCLONE, HARDCOPY, MAX, MEGACORE, NIOS, QUARTUS, STRATIX, and all other brands, unless noted otherwise, and/or trademarks of Altera Corporation in the U.S. and other countries.