Article ID: 000098309 Content Type: Troubleshooting Last Reviewed: 06/05/2024

When using “HPS First Configuration mode,” why does INIT_DONE stay LOW even after the Stratix® 10 device enters user mode?

Environment

  • Intel® Quartus® Prime Pro Edition
    • BUILT IN - ARTICLE INTRO SECOND COMPONENT
    Description

    Due to a problem in the Quartus® Prime Pro Edition Software version 23.4 and earlier, you might see a miss report of the INIT_DONE status register on Stratix® 10 SoC devices. This happens only when using HPS First Configuration mode. Executing the SDM mailbox command “CONFIG_STATUS,” word 3 bit 1 will incorrectly report INIT_DONE as LOW even after the device successfully enters user mode.

     

     

    Resolution

    This problem is scheduled to be fixed on a future version of Quartus® Prime Pro Edition Software.

    Related Products

    This article applies to 1 products

    Intel® Stratix® 10 FPGAs and SoC FPGAs

    Need more help?

    Contact support

    Disclaimer

    1

    All postings and use of the content on this site are subject to Intel.com Terms of Use.