Article ID: 000095958 Content Type: Troubleshooting Last Reviewed: 09/05/2023

Why can't I use the Clock Controller or Power Monitor of the Board Test System (BTS) GUI on the DK-DEV-AGI027RBES by default switch settings?

Environment

BUILT IN - ARTICLE INTRO SECOND COMPONENT
Description

Due to the default settings of the SW4 (off/off/on/off) on the Intel Agilex® 7 FPGA I-Series Development Kit (2 x R-Tile and 1 x F-Tile)with ordering part number (OPN) AGIB027R29A1E2VR3, the main I2C bus is used by the Intel Agilex® 7 device and so, is not available for the clock controller and the power monitor of the BTS.

Resolution

To use the Clock Controller and Power Monitor in BTS, disable the main I2C bus by putting SW4[1:4] to on/off/off/off.

Related Products

This article applies to 2 products

Intel Agilex® 7 FPGAs and SoC FPGAs I-Series
Intel Agilex® 7 FPGA I-Series Development Kits

Need more help?

Contact support

Disclaimer

1

All postings and use of the content on this site are subject to Intel.com Terms of Use.