Article ID: 000089964 Content Type: Troubleshooting Last Reviewed: 01/26/2023

Why does SEU fault injection fail after CvP update configuration on Intel® Agilex™ devices?

Environment

  • Intel® Quartus® Prime Pro Edition
  • BUILT IN - ARTICLE INTRO SECOND COMPONENT
    Description

    Due to a problem in the Intel® Quartus® Prime Pro Edition Software version 22.1 and earlier, performing single event upset (SEU) fault injection might fail after the second CvP update on Intel® Agilex™ devices. 

     

    When the FPGA is configured with a periphery image and then followed by the CvP update, the fault injection is working as expected. You might observe fault injection failure if you do a subsequent CvP update.

    Resolution

    To work around this problem, you need to power cycle the device. Reconfiguration will not fix the problem.

     

    This problem is fixed starting with the Intel® Quartus® Prime Pro Edition Software version 22.2.

    Related Products

    This article applies to 1 products

    Intel® Agilex™ 7 FPGAs and SoC FPGAs

    Disclaimer

    1

    All postings and use of the content on this site are subject to Intel.com Terms of Use.