Article ID: 000088131 Content Type: Error Messages Last Reviewed: 11/02/2021

Error (209053): Unexpected error in JTAG server --error code 44

Environment

  • Intel® Quartus® Prime Standard Edition
  • Windows® 10 family

    BUILT IN - ARTICLE INTRO SECOND COMPONENT
    Description

    You may see this error message when configuring a Stratix® V device using JTAG configuration scheme if all the following conditions are met:

    • Operating system: Windows 10
    • jtagserver version: 19.1 Standard Edition or later
    • Download cable: Intel® FPGA Download Cable

     

    Resolution

    To work around this problem, use jtagserver version 18.1 Standard Edition instead.  The jtagserver version 18.1 Standard Edition is installed when the Intel® Quartus® Prime Standard Edition Software v18.1 or Intel Quartus Prime Standard Edition Software v18.1 Programmer and Tools is installed.

    Use the following steps to check the jtagserver version:

    1. Open a Command Prompt window.
    2. Execute the following command:
      jtagserver -v

    If the jtagserver version is not Standard Edition v18.1, use the following steps:

    1. Open a Command Prompt window.
    2. Go to
      <Intel® Quartus® Prime 18.1 Standard Edition install directory>\quartus\bin64
      or
      <Intel® Quartus® Prime 18.1 Standard Edition Programmer and Tools install directory>\qprogrammer\bin64
    3. Execute the following command:
      qreg.exe --force --setqdir --jtag

    Related Products

    This article applies to 2 products

    Stratix® V FPGAs
    Intel® FPGA Download Cable

    Disclaimer

    1

    All postings and use of the content on this site are subject to Intel.com Terms of Use.