Article ID: 000087065 Content Type: Troubleshooting Last Reviewed: 04/15/2023

Why does reconfiguration through a non-JTAG source fail after first programming via JTAG in Intel® Stratix® 10 device?

Environment

    Intel® Quartus® Prime Pro Edition
    Config Debug Agent Intel® FPGA IP
    Configuration and Programming
BUILT IN - ARTICLE INTRO SECOND COMPONENT
Description

Due to a problem starting with the Intel® Quartus® Prime Pro Edition Software version 18.0,  if your Intel® Stratix® 10 device is first configured via JTAG, you cannot subsequently reconfigure via a non-JTAG source. 

Resolution

To work around this problem, power cycle your Intel® Stratix® 10 device if the failure occurs.

This problem is fixed starting in Intel® Quartus® Prime Software v19.1.

Related Products

This article applies to 1 products

Intel® Stratix® 10 FPGAs and SoC FPGAs

1

Need more help?

Contact support

Disclaimer

1

All postings and use of the content on this site are subject to Intel.com Terms of Use.