Article ID: 000086742 Content Type: Error Messages Last Reviewed: 01/25/2023

Error(19192): File <filename>.sof is incomplete - Power management settings are not set up appropriately on VID part

Environment

  • Intel® Quartus® Prime Pro Edition
  • BUILT IN - ARTICLE INTRO SECOND COMPONENT
    Description

    You may see this error when compiling a design targettting -V (SmartVID) enabled Intel® Stratix® 10 devices in the Intel Quartus® Prime Pro Edition Software if you have not assigned the SmartVID power management signals to SDM_IO and have not appropriately configured the Power Management & VID section in your project.

    Resolution

    In the Intel® Quartus® Prime Pro Edition Software, you must assign the SmartVID power management signals to appropriate SDM_IO pins under Assignments -> Device -> Device & Pin Options -> Configuration -> Configuration Pin Options. In addition, when operating in PMBus Master/Slave mode, you must assign a non-zero address to the device address under Assignments -> Device -> Device & Pin Options -> Power Management & VID.

     

    Related Products

    This article applies to 1 products

    Intel® Stratix® 10 FPGAs and SoC FPGAs

    Disclaimer

    1

    All postings and use of the content on this site are subject to Intel.com Terms of Use.