Article ID: 000086675 Content Type: Troubleshooting Last Reviewed: 07/09/2018

Is it possible to configure only one of the configuration pins nCONFIG, nSTATUS and CONF_DONE as user I/O pin in Intel® MAX® 10 device?

Environment

BUILT IN - ARTICLE INTRO SECOND COMPONENT
Description

In Intel® MAX® 10 devices, when configuring the configuration pins nCONFIG, nSTATUS and CONF_DONE as user I/O pins, it is not possible to select only one of them. Either all three of them can used as user I/O pins or none of them.

Resolution

There is no plan to change this behavior in Intel MAX 10 devices.

Related Products

This article applies to 1 products

Intel® MAX® 10 FPGAs

Disclaimer

1

All postings and use of the content on this site are subject to Intel.com Terms of Use.