Article ID: 000086380 Content Type: Troubleshooting Last Reviewed: 03/08/2022

Why does my Intel® Stratix® 10 design fail to boot / read from QSPI when using the Intel® Quartus® Prime Pro Software version 21.1 or 21.2 to create full flash images such as .JIC / .RPD files?

Environment

  • Intel® Quartus® Prime Pro Edition
  • BUILT IN - ARTICLE INTRO SECOND COMPONENT

    Critical Issue

    Description

    Due to a problem in the Quartus® Programming File Generator in the Intel® Quartus® Prime Pro Software version 21.1, and 21.2,   block partitions containing raw data files (.hex, .bin, .puf or .wkey) may be incorrectly re-sized in full flash images (.JIC / .RPD files).

    This problem may result in run-time boot failures,  data corruption,  or QSPI corruption when Intel® Stratix® 10 Hard Processor System Remote System Update (RSU) flows are used to update flash content. 

    Resolution

    Patch 0.14 for the Intel® Quartus® Prime Pro Software version 21.2 is available to fix this problem.  

     1. Download and install the patch from the relevant link below

    2. Re-Create the Flash image clean,  re-entering all partition data and sizing.

    3. Re-program your QSPI flash using the new .JIC / .rpd file

     

    This problem is fixed starting with the Intel® Quartus® Prime Pro Edition Software version 21.3.

    Related KDB : Is there any problem when raw data file is added in a programming file using Block Address Mode?

     

     

    Related Products

    This article applies to 2 products

    Intel® Stratix® 10 FPGAs and SoC FPGAs
    Intel® Agilex™ 7 FPGAs and SoC FPGAs

    Disclaimer

    1

    All postings and use of the content on this site are subject to Intel.com Terms of Use.