Article ID: 000084677 Content Type: Troubleshooting Last Reviewed: 05/16/2014

Is there a known issue with the scandata port when using the ALTPLL_RECONFIG megafunction in the Quartus® II software version 13.1?

Environment

    Quartus® II Subscription Edition
BUILT IN - ARTICLE INTRO SECOND COMPONENT
Description

The scandata output port in the ALTPLL_RECONFIG megafunction has been inverted in the Quartus® II software version 13.1.

Resolution

This problem is scheduled to be fixed in a future release of the Quartus II software. A patch is available to fix this problem for Quartus II software version 13.1. Download and install patch 0.81 and recompile your design. Quartus II versions earlier than 13.1 are not affected.

 

Related Products

This article applies to 10 products

Arria® II GX FPGA
Arria® II GZ FPGA
Cyclone® III FPGAs
Cyclone® III LS FPGA
Cyclone® IV E FPGA
Cyclone® IV GX FPGA
Stratix® III FPGAs
Stratix® IV GX FPGA
Stratix® IV GT FPGA
Stratix® IV E FPGA

1

Need more help?

Contact support

Disclaimer

1

All postings and use of the content on this site are subject to Intel.com Terms of Use.