Article ID: 000082859 Content Type: Troubleshooting Last Reviewed: 09/11/2012

Why can't I successfully program the Stratix device on the Stratix PCI Development Board (Standard or Pro edition)?

Environment

  • PCI
  • BUILT IN - ARTICLE INTRO SECOND COMPONENT
    Description If it appears that the Stratix device immediately restarts configuration and reverts to the factory image, the reason may be because there is contention on the board with the unused pins in your design. To avoid this problem, you must set all unused pins in your design "as inputs tri-stated." This is a Quartus II setting found in the Assignments -> Settings -> Device -> Device & Pin Options -> Unused pins.

    Related Products

    This article applies to 1 products

    Stratix® FPGAs

    Disclaimer

    1

    All postings and use of the content on this site are subject to Intel.com Terms of Use.