Article ID: 000080762 Content Type: Troubleshooting Last Reviewed: 08/13/2012

Why are my configuration pins not shown correctly in the .pin file for a design targeting a Stratix IV GT device?

Environment

BUILT IN - ARTICLE INTRO SECOND COMPONENT
Description

Due to a problem in the Quartus® II software versions 10.1 and later, the pin-out file (.pin) generated for a Stratix® IV GT device incorrectly shows the CONF_DONE and nSTATUS pins as GND*.

This problem is fixed beginning with the Quartus II software version 11.0.

Related Products

This article applies to 1 products

Stratix® IV GT FPGA

Disclaimer

1

All postings and use of the content on this site are subject to Intel.com Terms of Use.